SCANCLIMBER 65H Series, Instruction Manual

Page: 100 / 164

18
V115E_09.20 T r o u b l e s h o o t i n g
Series-65H Hoist Pos 4
Code
No.
Error entry Description Solution / what to do
F13 Security Circuit U12
One locking device contact has been
opened during travel and opened the
safety circuit or ramp is open
Check all locking devices and/or
pins; check ramp
F14 Voltage 24V ZR
The ZKR's +24V DC power supply is in
overload conditions, resp. shorted in
the system
Check the output load: ZB1, ZB2
F16 Voltage 24V FKR
The ZKR’s +24V DC power supply is in
overload conditions, resp. shorted in
the system.
Check the output load: FE1, FE2,
FE3, IC0, IC1, IC3, IC4, ID3, ID4, ID5,
IE5
F19 Zone Switch
No signal from the zone sensor on the
landings.
Check the position of the cam on
the landing
F41 Regulation Fault The regulation (inverter) has a problem Check the inverter (in OP6) front
panel for more information
F43 Temperature Switch
Cabinet 1
The Box OP1 temperature is too cold
–> limit 1(B600 Switch Cabinet T-Min)
Check heaters
F44 Temperature Switch
Cabinet 2
The switch cabinet temperature is too
hot –> limit 2 (B600 Switch Cabinet
T-Max)
Check heaters
F45 Motor Temperature The PTC of the engine has activated.
Reaction according configuration.
Check if motor isn't too hot or
cold
F46 Journey Time Start
The configured delay(B600- Start Time
Monitor) for the Start Time Monitor has
elapsed. After a configured number of
trials, the installation is locked.
Check locking door or check ramp
close or check mount and connec-
tion encoder; check the breaks
F47 Journey Time Travel
The configured delay(B600- Journey
Time Monitor) for the Journey Time
Monitor has elapsed. Reaction accor-
ding configuration.
Check mount and connection
encoder
F48 Journey Time Dece-
leration
The configured delay(B600- Decelera-
tion Time Monitor) for the Deceleration
Time Monitor has elapsed. Reaction
according configuration.
Check mount and connection en-
coder or the cam on the landing