SCANCLIMBER 65H Series, Instruction Manual

Page: 65 / 164

7
O p e r a t i n g i n s t r u c t i o n s Series-65H Hoist Pos 3
V115E_09.20
The start-up of the hoist with a PLC ver. 2 system is carried out as follows:
1. Switch the main switch (Q1 ) in the
ground station control box to posi-
tion”1”.
2. Check that the ground station emer-
gency stop button (S1) is released. If it
is not, turn the button clockwise and at
the same time pull it outwards.
3. The hoist is ready for use, when the
green pilot lamps (H65) “Normal op-
eration” on the ground station control
box +OP1 and (H65) “Ready” on the
hoist control panel +OP2 is switched
on.
4. The hoist is overloaded , when the yel-
low pilot lamp (H63) on the hoist con-
trol panel +OP2 is switched on. Re-
move the overload.
Q1 - Main switch
H65 - Normal operation
H66 - Out of service
2xA - Call on
STOP - Emergency stop
H65
Ready Overload Out
of service
Cage
light
Alarm
H63 H66
1 2 3
4 5 6
7 8 9
*
0 #
S103 S30
S60.1
EMERGENCY
STOP
60 %
ON
80 %
100 %
cage position
selected floor
call input
+OP2
Remote control box
- use for service drive
(located inside the
+OP2 BOX)
5.
The hoist’s safety circuit is discon-
nected, when the red pilot lamp
(H66) “Out of service” on the ground
station control box +OP1 and (H66)
“Out of service” on the hoist control
panel +OP2 is switched on. When
the safety circuit is disconnected
the hoist cannot operate.
H66
2xA
Q1
H65
+OP1