SCANCLIMBER 65H Series, Instruction Manual

Page: 63 / 164

5
O p e r a t i n g i n s t r u c t i o n s Series-65H Hoist Pos 3
V115E_09.20
3.2 The Hoist’s Start-up
1. Switch the main switch (Q1 ) in the
ground station control box to posi-
tion”1”.
2. Check that the ground station emer-
gency stop button (S1) is released. If it
is not, turn the button clockwise and at
the same time pull it outwards.
The start-up of the hoist with a relay control system is carried out as follows:
3. Switch the main switch (Q2) on the
hoist control panel to position “1”.
4. The power supply is in order, when
the “Power supply” pilot lamp (H1) on
the ground station control box door is
switched on.
5. The hoist is ready for use, when the
green pilot lamp (H4) “Ready for use”
on the hoist control panel is switched
on.
6. The hoist is overloaded , when the
red pilot lamp (H3) on the hoist con-
trol panel is switched on. Remove the
overload.
7. The hoist’s safety circuit is disconnect-
ed, when the yellow pilot lamp (H2)
“Safety circuit disconnected” on the
hoist control panel is switched on. This
pilot lamp is also found in the ground
station control box and in the call box-
es on the landings. When the safety cir-
cuit is disconnected the hoist cannot
operate.
-S1
-S2
-H1 -H2
-H11 -H12 -H13 -H14
-S4
-S3
-Q1