SCANCLIMBER 65H Series, Instruction Manual, Page: 67 / 164

9
O p e r a t i n g i n s t r u c t i o n s Series-65H Hoist Pos 3
V115E_09.20
1. Choose with the switch (S20)
“Mode selection” on the
cage control panel position
“1” – Automatic control.
2. Use the keyboard to se-
lect the desired floor, for in -
stance if you wish to get to
the fifth floor push the digit
key 5 and confirm by push -
ing the key # => the hoist
starts moving and stops au-
tomatically on the fifth floor.
Close the door/the gate at the ground station or on the landing and the hoist door.
3.3.2 PLC (Programmable Logic Control) - ver. 1
3.3.2.1 Automatic Control
-H4 -H3 -H2 -S3
-S2
I On
-Q2
O I
1 2 3
4 5 6
7 8 9
*
0 #
Off
I
-S15
-S16
-S20
EMERGENCY
STOP
PLC PROCESOR REMEMBER ONLY
16 CALLS.
17th CALL WILL BE SKIPPED.
☞
Main screen. On the bottom bar appears re-
member stops.
While travelling up the PLC sorts landings
into sequential order of low to high, then
low again for landings already passed and
stops according to this order.
Below are two exeptions to this:
1. When floor 0 is pressed while going up,
the lift will reverse direction after serv-
ing the highest floor in the list at that
point. Any further higher floors than
those already entered, which are en-
tered while still travelling up will not be
served until the hoist goes down to floor
0 then recommences serving floors as it
travels up again.
2. While travelling past a floor, if that floor
is entered just as the hoist is approach-
ing that floor, but has insufficient dis -
tance to stop, the hoist will continue to
its current active floor, then reverse di -
rection to go back to that floor, then
continue serving the current list of pro-
grammed floors in the original direc -
tion. If this operation is not desired, then
operators need to refrain from entering
a floor number just as that floor is being
approached.