SCANCLIMBER 65H Series, Instruction Manual

Page: 163 / 164

Inspection forms
V115E_09.20
Series-65H Hoist Pos 8
SC HOIST INSPECTION FORMS
18.
Check the control system fault x
Test
19.
That the motor, gearbox and it’s base plate bolts are tight
and that there are no oil leaks in the gear box.
x
Visual
Tighening
20.
Check lubrication and maintenance point (mast rack,
drive pinions, safety device pinion)
x
Visual, Grease
See chapter 5.3.2
21.
Check oil level of the motor and gearbox. There are no
oil leaks? Oil leaks immediately reported. Determine the
cause of an oil leak. If necessary add the oil or completely
change.
see separate manual
22.
Check the fastenings of the safety brake. x Tighening
23.
Lubricate the safety brake sliding bearings and the pinion
bearings.
x
Lubricate
Grease
24.
Check the operating the cable trolley and fastening of
aluminium reails
x Test
25.
That the hoist’s control buttons work on the ground stati-
on/ cage/landings
x Test
26.
That the brakes work properly and that the safety brake is
in working order
x
Test
27.
Check the condition /wear of the rack and pinion. x
Meansure
See chapter 5.4.6
28.
Check the condition of the gear - rack toothing. x
Visual, Meansure
See chapter 5.4.4
29. Clean the cable basket
x Visual
30.
Check the mounting and operation of all mechanical and
electric locks (landings, ground station, cage)
x Test
31.
That the doors and landing gates/ramp/doors open and
close properly and the landings are in good condition
x
Test, Grese
32.
Check cams x Visual
32.
Check the brakes for electric motors (adjust the gap of
disk brake). One brake should stop the cage in full load.
x
Meansure
See chapter 5.4.1
33.
Check the fastening and condition of hydraulic hoses. x
Visual
Tightening
If the machine is being used more frequently, or if operation is not interrupted
during several shifts the tooth rack will have to be lubricated more often according to
that more intensive use.
☞