SCANCLIMBER 65H Series, Instruction Manual

Page: 64 / 164

O p e r a t i n g i n s t r u c t i o n s
6
V115E_09.20
Series-65H Hoist Pos 3
-H4 -H3 -H2 -S3 -S2
I On
-Q2
O I
1 2 3
4 5 6
7 8 9
*
0 #
Off
I
-S15 -S16 -S20
EMERGENCY
STOP
1. Switch the main switch (Q1 ) in the
ground station control box to posi-
tion”1”.
2. Check that the ground station emer-
gency stop button (S1) is released. If it
is not, turn the button clockwise and at
the same time pull it outwards.
The start-up of the hoist with a PLC ver. 1 system is carried out as follows:
3. Switch the main switch (Q2) on the
hoist control panel to position “1”.
4. The power supply is in order, when
the “Power supply” pilot lamp (H1) on
the ground station control box door is
switched on.
5. The hoist is ready for use, when the
green pilot lamp (H4) “Ready for use”
on the hoist control panel +OP2 is
switched on.
6. The hoist is overloaded , when the yel-
low pilot lamp (H3) on the hoist control
panel +OP2 is switched on. Remove
the overload.
7. The hoist’s safety circuit is disconnect-
ed, when the red pilot lamp (H2) “Safe-
ty circuit disconnected” on the hoist
control panel +OP2 is switched on.
When the safety circuit is disconnect-
ed the hoist cannot operate.
-Q1
-H1
-S1
-H2
+OP2