SCANCLIMBER 65H Series, Instruction Manual

Page: 105 / 164

23
T r o u b l e s h o o t i n g
V115E_09.20
Series-65H Hoist Pos 4
KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V106-E 21.12.2016 Page - 173 -
limiter -> blocking the system.
F36 Releveling distance With the releveling the releveling area was left.
F37 Releveling- time With the releveling the maximum releveling time wasexceeded.
F38 Releveling Attemps With the releveling the maximum number of attempts was ex-
ceeded.
F39 Quick Start This message is entered, if the Quick Launch the feedback E524
is not right. Only fault entry, no interruption of movement. The
journey starts in case of error without quick start.
F41 Regulation Fault The regulation ( inverter) has a problem
F42 Batterymonitor The Battery of EOS or other external Units is too low
F43 Temperature Switchcabinet 1
The switchcabinet temperature is too cold –> limit 1
F44 Temperature Switchcabinet 2 The switchcabinet temperature is too hot –> limit 2
F45 Motor temperature The PTC of the engine has activated. Reaction according config-
uration.
F46 Journey Time Start The configured delay for the Start Time Monitor has elapsed.
After a configured number of trials, the installation is locked.
F47 Journey Time Travel The configured delay for the Journey Time Monitor has elapsed.
Reaction according configuration.
F48 Journey Time Deceleration
The configured delay for the Deceleration Time Monitor has
elapsed. Reaction according configuration.
F49 Journey Time Stop The configured delay for the Stop Time Monitor has elapsed.
Reaction according configuration.
F51 Brake opening monitor
There is no expected signal levels at the monitoring braking in-
puts of the control DAVID-613
F52 Brake shoe monitor The monitor for the brake wear has been activated. Reaction
according configuration.
F53 Contactor Stop The monitor for the main and brake relay has been activated.
Reaction according configuration.
F54 Brake opening synchronization The monitoring of the braking elements has been activated. One
of the monitor inputs is out of order or it is slower than the other
(s) channel. Please check it.
F55 Contactor Travel The monitor for the main and brake relay has been activated.
Reaction according configuration.
F56 Phase Change The ranking of the phases U,V,W is wrong
F57 Brake & Bolt Voltage
The voltage monitor of the brake & bolt has send an error
F58 Low Pressure The pressure of the hydraulic is too low
F59 Rope Stretching Error message loadmeasurement-systemes about an uneven
stretching of a rope.
F60 A3 - Case
The car has left the floor with the door open and the lift was
blocked. (Even in Simmulation!)
Three different ways to Reset of the error “F60 A3-Case”:
1.) In the menu C0 Controller Reset
2.) Simultaneously press the three buttons maintenance call top-
down call on the central unit ZR.
3.) De-energizing the FKR in the inspection box.
F61 Door Close The door could not be closed within the configured time.
F62 Separation Door
The door could not be opened within the configured time.
F63 Flap Apron The folding apron does not drive although the lowest Stop be-
came to leave.
F65 Push-Button landing call up Tracer landing call up wedges
F66 Push-Button landing call down
Tracer landing call down wedges
F67 Push-Button Door open It takes place an entry if the tracer is operated longer than 45
seconds in the stop and/ or in normal operation.
F68 Photocell blocked It takes place an entry if the lght barrier is operated longer than
45 seconds in the Stop and/ or in normal operation.