R&S ZVH
Working with the Measurement Wizard
Analyzing Measurement Results
Operating Manual 1309.6946.12 - 09
68
3
Working with the Measurement Wizard
When testing antennas and cables it is often necessary to perform a sequence of
standardized and recurring measurements, often in an environment that is not easily
accessible. To make sure that measurements are performed as required and to avoid
a constant adjustment of parameters, the R&S ZVH features a measurement wizard.
The measurement wizard allows you to combine several individual measurement
configurations to a sequence of measurements (or measurement set). Because all
relevant parameters have been set prior to the actual measurement and cannot be
changed once the measurement procedure has begun, the wizard is a good way to
avoid mistakes and save time when setting up measurements.
This chapter describes the functionality of the measurement wizard. For details on the
individual measurements you can perform with the wizard, refer to the corresponding
chapters.
●
on page 37
●
Spectrum Analyzer Mode (R&S ZVH-K1)
on page 78
●
Network Analyzer Mode (R&S ZVH-K42)
on page 176
You can use the wizard for measurements in all operating modes.
Note that it is necessary to install and use the R&S ZVHView software package if you
want to access the measurement wizard.
