T
echnical
B
ulletin
PAGE: 30/58
Model:
Taurus-C1 / P1
Date:
21-Oct-11
No.:
RD074026
< Fusing Unit \ Heating Roller >
The following procedure was deleted as grease application for the Hot Roller Bearings is no longer
needed.
11. Before you remove the heating roller, cut out the pattern shown above. (You will need this to remove the
heating roller.)
• Use moderately thick paper, but it should bend easily.
• The pattern above is drawn to scale, so you can copy it and cut around it.
• This cutout will protect the heating roller from contamination by grease as it is removed.
12. At the front, insert the wider edge of the cutout between the heating roller and fusing belt at [A].
13. With the cutout between the roller and belt, rotate the cutout about 180° to the right until it is positioned
as shown at [B].
14. While holding the cutout at [A] so that it does not move, pull out the heating roller [B] from the front.
