Ricoh D3GF, Field Service Manual

Page: 147 / 187

4.System Maintenance
141
LED
error
code
Operation
type
Description Suggested action
11 - Failed to retrieve product
information.

It is not a Fiery Controller.

If the Fiery Controller is found, the
hardware might not have initialized
properly to retrieve the product name.
02 - Unsupported Fiery
Controller
Product information is found, but Fiery Clone
Tool does not support this product.
03 - Incorrect number of disks
detected.
Check the Fiery Controller to verify HDD
installation.
An incorrect disk configuration was detected,
which is not supported by Fiery Clone Tools for
Embedded Servers.
05 Backup Insufficient USB flash disk
space
Make sure that the USB flash drive has enough
space for the cloned image when you back up
the Fiery Controller.
08 Backup File operation error. I/O
error when writing to the
USB.
1.
Run Windows Disk Error Check on the
USB flash drive.
2.
Prepare the USB flash drive again using
the Fiery USB Setup Tool.
09 - Missing HDD Check the Fiery Controller to verify HDD
installation.
0F Backup Failed to write to USB flash
drive, or error reading from
HDD.
1.
Run Windows Disk Error Check on the
USB flash drive.
2.
Prepare the USB flash drive again using
the Fiery USB Setup Tool.
3.
Check the HDD if USB flash drive is
working properly, then try again.
10 - Failed to read service
switch position
Check if the service switch cable is connected
properly to the motherboard.
20 Backup Encountered an
unsupported file system on
the Fiery Controller
The Fiery Controller is not properly installed.
Reinstall the Fiery Controller.

If Fiery Clone Tool cannot read the
HDD partition, then the backup
procedure cannot be performed.
21 Backup
and restore
Failed to mount HDD
partition
The Fiery Controller is not properly installed.
Reinstall the Fiery Controller. If Fiery Clone Tool