Ricoh D3GF, Field Service Manual

Page: 137 / 187

4.System Maintenance
131
replaced and is currently empty.

If more than one customized backup files are included in the USB flash drive, the newer one
will be restored.

The following procedure is applicable only if the backup was created on a USB flash drive with
the “Create bootable image” option selected.
1.
Perform the shut down procedure from the copier operation panel [Link to Shutting Down the E-
25C Only ].
2.
When the E-25C power is down (that is when the diagnostic LEDs are off), turn the main power
switch of the E-25C to OFF.
3.
Set the E-25C service switches as shown below. (“1” ON, “2” OFF)
4.
Connect the USB device to a port on the E-25C.
For the fastest restoration, use a USB 3.0 flash drive. Make sure to connect the flash drive to the
USB 3.0 port at the rear side of the E-25C.
5.
Turn the main power switch of the E-25C to ON, then press and release the soft power push button
on the front of the E-25C.
6.
Allow the E-25C to boot from the USB device.
7.
Wait until the diagnostic LEDs on the rear panel of the E-25C flash “AA” then “00” repeatedly to
indicate ready status.
8.
Set the service switches to the following position. ( “1”OFF, “2” OFF)

The diagnostic LEDs display "C0" to indicate that the E-25C is ready to be restored.