Raymarine A65, Installation And Operation Instructions Manual

Page: 62 / 308

1. Remove the front bezel. Refer to the separate instructions
provided for that procedure.
D12184-3
e7 / e7D
1
3
2
2. Remove the screws that secure the bezel to the display (only
required for e7 and e7D).
3. Carefully remove the bezel from the rear of the display, pulling
the bezel gently along the:
i.
Outer edges - work from the sides upwards and then along
the top edge, ensuring that the clips are fully released from
the display.
ii. Inner edges - ensure that the bezel is completely removed
from the display.
Note: Only the e7 and e7D have fixing screws for the rear bezel,
other multifunction display variants have clips which hold the rear
bezel in place.
Flush mounting
You can mount the display in a flush or panel mounting arrangement.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will take.
• Detached the front bezel.
D 12271-1
1. Check the selected location for the unit. A clear, flat area with
suitable clearance behind the panel is required.
2. Fix the appropriate cutting template supplied with the product, to
the selected location, using masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated on the template),
make a hole in each corner of the cut-out area.
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. Ensure that the unit fits into the removed area and then file
around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to accept the securing
screws.
7. Place the gasket onto the display unit and press firmly onto the
flange.
8. Connect the power, data and other cables to the unit.
9. Slide the unit into place and secure using the provided screws.
Note: The appropriate torque to use when drilling depends on the
thickness of the mounting surface and the type of material.
Note: The supplied gasket provides a seal between the unit and
a suitably flat and stiff mounting surface or binnacle. The gasket
should be used in all installations. It may also be necessary to
use a marine-grade sealant if the mounting surface or binnacle is
not entirely flat and stiff or has a rough surface finish.
Attaching the rear bezel
The rear bezel must be fitted if you wish to use a mounting bracket
to mount the unit.
Note: These steps do not apply to the e165 as it does not require
a rear bezel.
1. Remove the front bezel. Refer to the separate instructions
provided for that procedure.
2. Place the bezel over the rear of the display, ensuring that it is
correctly aligned with the display. Apply firm but even pressure
to the bezel along the:
i.
Outer edges - work from the sides upwards and then along
the top edge, to ensure that it clips securely into position.
ii. Inner edges - ensure that the bezel sits flat against the unit.
D12183-3
e7 / e7D
1
2
3
3. Use the supplied screws to secure the bezel to the display (e7
and e7D only).
Bracket (trunnion) mounting
The display can be mounted on a trunnion bracket.
Note: The mounting bracket is supplied with the e7 and e7D
display variants, for all other display variants the mounting
bracket is an optional accessory See the
Spares and Accessories
section of this manual for details.
62 New a Series / New c Series / New e Series