Raymarine A65, Installation And Operation Instructions Manual

Page: 268 / 308

Menu item Description Options
should set this option to OFF to ensure that all NMEA-connected
units receive heading data from the external heading sensor.
NMEA Output Settings Allows you to enable or disable the individual NMEA “sentences”
that are sent by the multifunction display to any devices
connected the NMEA output port. • APB
• BWC
• BWR
• DBT
• DPT
• GGA
• GLL
• GSA
• GSV
• MTW
• MWV
• RMA
• RMB
• RMC
• RSD
• RTE
• TTM
• VHW
• VLW
• VTG
• WPL
• ZDA
NMEA Input Port 1
Enables you to specify the appropriate port speed for the
equipment connected to NMEA Input port 1. Use the AIS 38400
option for AIS receivers.
• NMEA 4800
• AIS 38400
NMEA Input Port 2 Enables you to specify the appropriate port speed for the
equipment connected to NMEA Input port 2. Use the AIS 38400
option for AIS receivers. • NMEA 4800
• AIS 38400
System preferences menu
Menu item Description Options
Bearing mode Determines how all bearing and heading data is displayed in.
This does not affect how the chart or radar displays are drawn. • True (default)
• Magnetic
Variation Source This setting compensates for the naturally occurring offset
of the earth's magnetic field. When set to Auto, the system
automatically compensates, and displays the compensation
value in brackets. To enter your own compensation value, use
the Manual option, then specify the value using the Manual
Variation setting (see below). This value is also transmitted to
any other connected Raymarine instruments. • Auto (compensation value displayed) (default)
• Manual
Manual Variation When the Variation Source menu item is set to Manual (see
above), you use the Manual Variation setting to specify the
compensation value that you want to use. • Range: 0 to 30 degrees, East or West
•
System Datum In order for your GPS receiver and multifunction display to
correlate accurately with your paper charts, they must be using
the same datum.
The default datum for your multifunction display is WGS1984. If
this is not the datum used by your paper charts, you can change
the datum used by your multifunction display.
When you change the datum for your multifunction display, the
chart grid will subsequently move according to the new datum,
and the latitude / longitude of the cartographic features will also
change accordingly. Your multifunction display will attempt to set
up any GPS receiver to the new datum, as follows:
• The internal GPS receiver will automatically correlate each
time you change the datum.
268 New a Series / New c Series / New e Series