2. Base & Tower
20
Original Prusa SL1 kit assembly
STEP 12
Mounting the adjustable feet
Install the second support from the other side of the printer. Again, ensure the
countersink is facing outwards and secure the support using two M3x8 screws.
Check the bottom plate and support outer surfaces are aligned. If not, release the
screws and readjust the support. Then tighten the screws again.
Turn the bottom of the printer towards you and locate the holes for the adjustable
feet.
Screw the adjustable feet all the way in.
Now you can place the printer on its feet and remove the cardboard. However, keep
it for later use.
STEP 13
Preparing PSU cables
For the following steps, please
prepare:
Power panic cable (1x)
Power cable (1x)
STEP 14
Connecting the cables
Connect both cables to the PSU
and guide them to the left side of
the printer. Cables are symmetrical,
use any side with the connector.
See the holes, which will be used
later on to mount the reflector.
Guide the cable from the tower
motor in the indicated direction.
Summary of Contents for Original Prusa SL1
