Prusa Research Original Prusa SL1, Manual

Page: 58 / 92

4. Electronics & Lid
58 Original Prusa SL1 kit assembly
STEP 12 Preparing the electronics
Handle electronics with extreme care. Avoid touching chips and capacitors on
both boards, always use the edges. Keep it in the ESD bags for now.
For the following steps, please prepare:
PrusA64-SL1 board (1x)
Motion controller (1x)
Electronics holder (1x)
M3x5 screw (8x)
Thermal pad (1x)
There is a
RED sticker on the PrusA64-SL1 board, don't peel it off!
STEP 13 Glueing the thermal pad
Before you continue, please clean the bent part of the holder with IPA cleaning pad.
Take the thermal pad and carefully peel off the clear protective film from the white
side.
Glue the pad to the electronics holder with the exposed side. Press the entire
surface of the pad to ensure proper connection.
Carefully peel off the second (blue) protective film. The pad is now quite sticky,
avoid touching it.
There is an extra pad in the spare bag ;)