Prusa Research Original Prusa SL1, Manual

Page: 79 / 92

5. Preflight check
Original Prusa SL1 kit assembly 79
STEP 12 Setup Wizard 10
Right now, you should hear a sound coming from the speaker near the touchscreen.
Congrats! The setup part is finished. Now, let's calibrate the printer.
STEP 13 Calibration 1
Now it is time to rotate the printing platform, so it fits in the resin tank.
Release the black knob slightly and pull the platform out.
Insert the platform back in, but this time according to the picture. Edges of the
platform should be parallel with the edges of the tank.
Tighten the knob again.
Press "Continue"
STEP 14 Calibration 2
Carefully release the screw(s) on the cantilever. Two turns are enough. Make sure
not to unscrew them completely.
Press "Continue"
STEP 15 Calibration 3
Release and remove both screws on the resin tank. Place them outside the printer.
Rotate the tank by 90° on the printer.
Behind the scenes: We will use the tank to calibrate the tilting mechanism. The tank
will work as a levelling tool to set the tilt horizontal.
Press "Continue"