Prusa Research Original Prusa SL1, Manual

Page: 76 / 92

5. Preflight check
76 Original Prusa SL1 kit assembly
STEP 1 Printer calibration
In the following steps, we will go
through the entire process of the
calibration.
Plug the printer in, ensure the PSU
switch is on and press the button on
the front to turn the printer on.
Follow the instructions on the
touchscreen and use this chapter to
get extra information regarding
each step.
DON'T POUR THE RESIN in the
tank until you are asked to by the
printer!
Never service the printer with the
resin inside!
Spilling the resin inside the printer
will most probably end up
damaging the SL1. Be careful!
Never look inside the printer during
the calibration of the screen or UV
LED. There is a risk of
PERMANENT DAMAGE to your
eye(s).
STEP 2 Unboxing Wizard
Please make sure you have removed the protective film.
Confirm and then end this short unboxing Wizard by pressing "Continue"
STEP 3 Setup Wizard 1-2
Welcome to the initial Setup Wizard , which will guide you through the basics of
the initial setup.
Open the acrylic lid all the way up.
If the resin tank is present, please unscrew the screws, remove them and then
remove the tank.
Click on Continue.