5. Preflight check
Original Prusa SL1 kit assembly
77
STEP 4
Setup Wizard 3
In this step, it is time to remove the printing platform.
Loosen the black knob and remove the platform.
Place the platform on a soft piece of fabric! You can use the same as during the
assembly. Never place the platform directly on the table!
Press "Continue" and wait until all the checks are done.
STEP 5
Setup Wizard 4
MAKE SURE THERE IS NO TANK AND NO RESIN
inside the printer!!!
We are going to the test the UV LED, any resin present in the tank will be hardened.
This test takes around 2 minutes.
Before you continue, close the lid.
Press "Continue"
STEP 6
Display test
Don't open the lid under any circumstances, keep it closed!
There is a UV light
inside, which will cause damage to your eyes.
Take look from above the printer. Your eye level needs to be above, not in front.
Otherwise, you won't be able to judge the result correctly.
Check the entire screen, you must be able to see our company logo in full. No parts
(letters) should be missing.
Summary of Contents for Original Prusa SL1
