Prusa Research Original Prusa SL1, Manual

Page: 28 / 92

2. Base & Tower
28 Original Prusa SL1 kit assembly
STEP 29 Tilt preassembly parts preparation
For the following steps, please
prepare:
Tilt preassembly (1x)
Resin sensor cable (1x)
M4x6r screw (1x)
M4w serrated lock washer (1x)
In case you are missing the second
washer, use the spare bag.
STEP 30 Resin sensor cable assembly
Rotate the tilt preassembly with the hole being on the right side.
Before you attach the cable, make sure you are using the correct hole:
The correct hole for the resin sensor cable.
Incorrect holes, avoid using them.
Place the M4 washer on the correct hole first. Don't place the cable on the tilt,
otherwise, you will have issues later!
Add the cable on the top of the washer and secure it using an M4x6r screw. Make
sure the cable is facing to the back. Tighten the screw properly, we need the
washer to "bite" in the surface of the tilt, but be careful not to damage the screw.
It is very important that the washer is in direct contact with the surface of the tilt.
Make sure you didn't switch the order!