Printronix N7000 H-Series, User Manual

Page: 201 / 292

N7000 STD ASCII Printers Fault Messages
201
POWER SUPPLY HOT Yes Power supply sensors
report high temperatures. Check printer environment. If hot or
dusty, relocate printer. Contact your
authorized service representative if
this occurs frequently.
1
PRINTER HOT Yes This message indicates
internal temperatures
over 60° Celsius (140°
Fahrenheit). Check printer environment. If hot or
dusty, relocate printer. Contact your
authorized service representative if
this occurs frequently.
1
PRINTER UNDER
REMOTE CONTROL No Status message: The
printer is under the
control of PrintNet
Enterprise (PNE) remote
management software. No action is required.
PROTECTED INSTR* No Protected Instruction.
Firmware error on
controller board. Contact your authorized service
representative.
1
PWR SUPP VOLT * No Power Supply Voltage.
The power supply has
failed. Replace power supply board.
RBN AT END POINT
Change Ribbon Yes Integrated Print
Management System
software has determined
that the ribbon is out of
ink. Install a new ribbon.
REGIONx MISMATCH
Use Correct RBN Yes The incorrect cartridge
type is being used for the
printer. “X” indicates the
region of the printer. Install Region X ribbon cartridge in
the printer.
NOTE: Specify the region of the
printer when ordering
ribbons.
REMOVE USED SPX
THEN PRESS ENTER
No Status message: An SPX
is depleted because it
has successfully
reprogrammed the
security key on the
controller board. Contact your authorized service
representative.
1
RESTORING BOOT
CODE No Normal download
initialization message. No action is required.
RIB INVLD CMD*
See User Manual
Yes Ribbon Invalid
Command. Firmware
error on the controller
board. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again. If the message appears
again, contact your authorized
service representative.
1
Table 12. N7000 STD ASCII LCD Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution