Printronix N7000 H-Series, User Manual

Page: 59 / 292

N7000 H-Series Firmware
59
N7000 H-Series Firmware
OFFLINE
CONFIG.
CONTROL
page 64
Load Config.
Save Config.
Print Config.
Delete Config.
Power-Up Config.
Protect Configs.
Name Configs
Reset Cfg Names
Auto Save
NOTE:
1
If installed
2
Available for Zero Tear Pedestal printers only.
3
Only for pedestal printers only.
4
Not available if PNE Port is set to Serial.
5
If a Feature File has been downloaded.
6
Available for N7H Hanzi GB printers when the OKI emulation is enabled.
QUICK
SETUP
page 60
Host Interface
Ethernet Address
ZTP Data Time
2
ZTP Wait Time
2
ZTP TearDistance
2
Graphic Spd Up
Typeface
DBCS CPI
Select LPI
DBCS ASCII Style
DBCS/ASCII Mode
Ribbon End Point
Reset Cmd CFG Ld
Load Config.
Save Config.
Power-Up Config.
HOST
INTERFACE
page 66
Ethernet
Auto Switching*
Centronics
Dataproducts
Serial
IEEE 1284
NETWORK
SETUP
page 81
Ethernet Address
Ethernet Params
PRINTER
CONTROL
page 145
Ribbon End Point
Open Platen @ BOF
Tear Bar Dist.
View Function
3
Unidirectional
Display Language
Accented Chars
ADVANCED
USER
page 148
Ptx Setup Option
Hex Dump Mode
Power-Up State
Downloaded Fonts
PMD Fault
Power Stacker
1
Auto Elevator
1
Auto Locking
File System
Set Sharing
Shuttle Timeout
Slow Paper Slew
Alarm
Power Saver Time
Pwr Save Control
Cancel Key
Rcv. Status Port
Ret. Status Port
Set Lock Key
Job Set/Typeface
Print Hist. Log
RBN Low Warn@
RBN Low Action
RBN End Action
DIAGNOSTICS
page 155
Printer Tests
Test Width
Paper Out Dots
System Memory
Print Statistics
Software Build
Feature File
5
Shuttle Type
PRINTER
MGMT
page 158
PNE Port
Mgmt Protocol
PNE Port Number
4
PNE Port Timeout
4
Status Port Numb
Mgmt Port Number
EMULATION
page 109
Line
Printer Protocol
LQ 1600K
OKI
6
ZTP
SETTINGS
2
page 255
ZTP Data Time
ZTP Wait Time
ZTP Tear Distance
ZTP Function
ZTP Platen Open