Printronix N7000 H-Series, User Manual

Page: 61 / 292

QUICK SETUP Menu Definitions
61
Active IGP Emulation
The Active IGP Emulation menu enables you to activate either the PGL or
VGL emulation (for the N7000 STD firmware only).
NOTE: Available for N7000 STD firmware only.
PGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
•
7E (the default)
•
1 – FF
NOTE: Available for N7000 STD firmware only.
VGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
•
5E (default)
•
1 – FF
NOTE: Available for N7000 STD firmware only.
Printer Protocol
Select the Line protocol you wish to use.
Form Length
Form length is the number of lines that can be printed on a page. You can set
the form length in inches, millimeters (mm), or as a function of the current lpi
(lines per inch).
Form Width
The form width can be specified in inches, millimeters, or as a function of the
current cpi (characters per inch). The forms width set should not exceed the
actual paper width.
Select CPI
This parameter allows you to specify the characters per inch (cpi) values.
The options are 10.0, 12.0, 13.3, 15.0, 17.1, and 20.0. The factory default is
10.0 CPI.
NOTE: Values 13.3, 15.0, 17.1, and 20.0 are not available on N7H Hanzi GB
printers with OKI selected.