Printronix N7000 H-Series, User Manual

Page: 217 / 292

N7000 H-Series Printers Fault Messages
217
D50 Status %XX
Clearing Flash
No Status message: The printer
is clearing its flash memory,
where %XX represents the
percentage completed. No action is required.
D51 Status %XX
Programming...
No Status message: The printer
is loading firmware, where
%XX represents the
percentage completed. No action is required.
D55 Status: Send
Program to EC No Status message: The printer
is loading the engine
controller program into the
engine controller (EC). No action is required.
DIAGNOSTIC
PASSED No Status message: the printer
passed its memory and
hardware initialization tests. No action is required.
DO NOT POWER OFF No Status message: The printer
is performing an operation
that must be completed
before you can cycle power. No action is required, but do not
power off the printer until the
operation is complete.
E00 EXE @ ADDR0
See User Manual Yes An illegal or unsupported
instruction was attempted in
the application program. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
E01A TYPE 0x40
See User Manual Yes An illegal or unsupported
instruction was attempted in
the application program. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution