Printronix N7000 H-Series, User Manual

Page: 63 / 292

QUICK SETUP Menu Definitions
63
Typeface
Sets the typeface of the printer. This key requires confirmation with the
ENTER key.
NOTE: Available for H-Series firmware only.
The factory default for Hanzi GB LP+ with LQ1600K selected is
Near LQ.
The factory default for Hanzi Big5 LP+ and Hanzi GB LP+ with OKI
selected is LQ.
DBCS CPI
Defines the default values for horizontal character spacing in DBCS mode.
For the Hanzi LP+ printer, select from 5.0, 6.0, 6.7, 7.5, Others CPI, and
Default (available for N7H Hanzi GB LP+ with OKI selected only).
The factory default is 6.7 cpi for LQ1600K and Default for OKI.
NOTE: Available for H-Series firmware only.
DBCS ASCII Style
This option specifies the appearance of the single-byte numeric characters.
For the Hanzi LP+ printer, select from Normal, Oversize and OCRB.
NOTE: Available for H-Series firmware only.
DBCS/ASCII Mode
This option specifies the operating mode of the Hanzi printer. Refer to “Font
Attributes” in the
LQ1600K Programmer's Reference Manual for more
information.
NOTE: Available for H-Series firmware only.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command
(ESC @
1,2
, ESC[K
1
, or DLE B
3
) in addition to resetting printer variables, the
selected configuration will be loaded.
•
Disable (default). The active emulation parameters are loaded when the
reset command is executed.
•
Power-Up Config . The power-up configuration is loaded when the reset
command is executed.
•
Current Config . The currently selected configuration is loaded when the
reset command is executed.
•
Factory Config . The factory installed configuration is loaded when the
reset command is executed.
NOTE: Available in the QUICK SETUP menu for H-Series firmware only.
NOTE 1: For N7 STD printer only.
NOTE 2: For N7H Hanzi GB LP+ with LQ1600K selected and Hanzi Big5 LP+
printer.
NOTE 3: For N7H Hanzi GB LP+ with OKI selected.