Printronix N7000 H-Series, User Manual

Page: 215 / 292

N7000 H-Series Printers Fault Messages
215
B21 STATUS:
PRINTER RESET No Status message informing
the operator that the printer
is undergoing a system
reset. No action is required.
B22 ERROR:
DECOMPRESS SIZE* No FLASH memory has not
passed boot initialization
tests. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B23 ERROR:
DECOMPRESS
CKSUM* No FLASH memory has not
passed boot initialization
tests. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B30 STATUS:
INITIALIZING... N/A Status message: the printer
is running its initialization
routines after startup and
successful memory tests. No action is required.
B35 STATUS:
WAITING FOR EC
STATUS
N/A Status message: the DC on
the controller board is
waiting for communication
with the EC. If this message
does not clear witin a few
seconds there is an
electrical or electronic
problem on the controller
board. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B40 ERROR: SDRAM
EEPROM CKSUM
BAD* No Flash memory has not
passed boot initialization
tests. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B41 ERROR: DIM
MEMORY NOT
SDRAM* No The DRAM DIMM installed
on the controller board is not
Synchronous DRAM
(SDRAM). Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B42 ERROR: SDRAM
ROWS NOT
ALLOWED* No Printer boot initialization
tests detect incorrect
SDRAM. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
B43 ERROR: SDRAM
TOO MANY BANKS* No Printer boot initialization
tests detect incorrect
SDRAM. Cycle power to see if the
message clears, if not, contact
your authorized service
representative.
1
Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution