Printronix N7000 H-Series, User Manual

Page: 209 / 292

N7000 H-Series Printers Fault Messages
209
437:REG MISSING
Use Correct RBN Yes The incorrect cartridge type
is being used for the printer. Install region X ribbon cartridge
in the printer.
NOTE: Specify the region of
the printer when
ordering ribbons.
438:TIP MISMATCH
Use Correct RBN Yes The incorrect cartridge type
is being used for the printer. Install the correct ribbon
cartridge type in the printer.
439:SHTL MISMATCH
Use Correct RBN Yes This message displays when
an Extended Life Ribbon is
mounted on a 3H printer. Install Standard Life Ribbon.
440:RWP DOWNLOAD
Please Wait No Status message indicating
the software in the cartridge
is being updated. The user
must wait fo rthe update to
complete. No action is required.
601:15V CTL FAIL* No Controller voltage failure. Contact your authorized service
representative.
1
602:23.5V CTL FAIL* No 23.5 Volt Controller failed: a
voltage failure on the
controller board. Contact your authorized service
representative.
1
604:48V CIRCUIT*
See User Manual
No Either the power supply is
not generating a proper 48
Volts or the controller board
is not detecting a 48 Volt
output from the power
supply board. Contact your authorized service
representative.
1
605:48V PWR FAIL* No Internal power failure. Contact your authorized service
representative.
1
606:Power 8.5V
CHECK No 8.5 Volt power failed.
Internal power failure. Contact your authorized service
representative.
1
607:CTL VOLT FAIL* No Controller Voltage Failure.
15 V failure on the controller
board. Contact your authorized service
representative.
1
608:DRIVER CIRCUIT
BAD No Driver Circuit Bad. The
hammer coil count test
failed. Contact your authorized service
representative.
1
Table 13. N7000 H-Series Fault Messages Troubleshooting
Displayed Message
Can User
Correct?
Explanation Solution