Compax3
device description
Positioning via digital I/Os
44
192-120101 N11 C3I11T11 November 2007
Controller front plate
X20
X21
X22
X23
S24
X12
X13
X11
X3
LED3
LED2
LED1
X4
X10
X3
Motor brake
X20
HEDA in (Option)
X4
24VDC
X21
HEDA out (Option)
X10
RS232/RS485 with jumper to the
programming interface
X22
Inputs Outputs (Option M10/12)
X11
Analog/Encoder
X23
Bus (Option)
connector type
depends on the bus
system!
X12
Inputs/Outputs
S24
bus settings
X13
Motor position feedback
LED1
Device status LEDs
LED2
HEDA LEDs
LED3
Bus LEDs
The
internal
device status LEDs are only connected to the
external
housing LEDs,
if the RS232 jumper at X10 is fitted to the control and the upper dummy cover is
fitted.
The RS232 programming interface under the upper dummy cover is only available
if the X10 jumper at the controller is fitted.
Always switch devices off before wiring them!
Dangerous voltages are still present until 5 minutes after
switching off the power supply!
Caution!
If the control voltage is missing and if the X10-X10 jumper is not
fitted (VBK17/01) on the control part, the availability of power voltage
is not displayed.
PE connection
The PE connection is made with 10mm
2
via a grounding screw at the
bottom of the device.
Attention hot surface!
Metal parts can heat up to a temperature of 90°C during operation.
Note on Compax3H:
