Quantum and Evolution Series Installation and Operating Handbook
7-79
If the number of timeslots that are entered differ from the number
entered on the previous screen then the new value will not be accepted
and the modem will continue to display this screen until a valid value is
entered.
Edit-Tx-Interface-Dropped Timeslot Idle Code Screen (Quad E1 interface card)
Options:
Leave on bearer
The Tx data remains on the bearer and will be accessible to downstream
equipment unless Rx data is inserted over it.
Replace with Idle code
The Tx data is replaced with Idle code.
Factory
default:
Leave on bearer
Description:
Controls whether dropped timeslots are replaced with Idle code in
relation to the specific port on the Quad E1 card. If the Rx data is to be
inserted into the same timeslots as the Tx data has been dropped from
then the Rx data will replace the Tx data and therefore this setting is
irrelevant.
Edit-Tx-Interface-Port 3 / Port 4 Screen (Quad E1 interface card)
Units:
bps
Minimum value:
0
Maximum value:
2048000
Step size:
64000
Port 1 dropped timeslots:
[Leave on bearer]
New: Leave on bearer
Tx Data Rate: 0 to 2048000bps
[0000000] step 64000bps
New: 0000000
