Panasonic LP-RF Series, Setup & Maintenance Manual

Page: 144 / 218

144
6-1-6 Image checker setting
Settings to use the image checker PV230/PV200 for link control with the laser marker are described below.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For specifications and setting of image checker PV230/PV200, refer to the instruction manual for PV230/PV200.
„
Communication settings of image checker PV230/PV200
To connect the laser marker with PV230/PV200, configure the PV230/PV200's communication settings as follows.
Item Ethernet communication specifications
Communication protocol Multipurpose communication (TCP/IP)
Port No.
(Fixed)
Result output 8601
Command transmission 8604
IP address Initial value: 192.168.1.5
Make sure that the IP address for the laser marker on the network is not overlapping the IP
address for the other external devices.
„
Input/output setting
To use the link control function with the laser marker and PV230/PV200, configure the system settings on the PV230/
PV200 as follows.
1.
From “Environment” - “Input/Output” setting screen of PV230/PV200, select the “General Output”.
2.
Set the items of Ethernet with the protocol setting “General
Com.” as follows.
• Output: Yes
• Operation: Synchronized
• Date/Time: No
• Scan Count: No
• Total Judge: Yes
• Judge: No *
• Numeric Calculation
For position correction : Yes
For other than position correction : No *
• Optical Character Recognition: No *
• Code Reader: No *
• BCC: No
• Number of Digits: 7
• Decimal Digit: 3
• Unused Digit: Fill with 0
• Error Output: No *
* : When you use Ethernet with the protocol setting both “PLC Com.” and “General Com.”, for the items with * you can
change the settings according to your PLC configuration. For the items without *, follow the above settings.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When the result of the total judgement by PV230/PV200 is “1”, the laser marker outputs CHECK OK OUT, and when the
result is “0”, CHECK NG OUT is output.
ME-LPRF-SM-11