Owandy Radiology i-max touch, Service Manual

Page: 72 / 267

SERVICE MANUAL
Installation
I-Max Touch 6-14
6.6. Inserting the sensor in the sensor holder
NOTE:
Not valid for PAN only version.
In order to insert the sensor in the desired station, carry out the following
operations:
1. Grip the sensor by the appropriate handgrip; close your fingers to
form a fist, by engaging the control lever and bring it to the position
where the lever disappears inside the handgrip, so that the whole
mobile system retracts.
2. Keep the sensor with the relative handgrips vertical, so that the
upper plane is parallel to the horizontal part of the sensor holder,
bring the sensor close to the fixed station, by engaging the protruding
part of the mobile sensor into the relative casing.
3. Push the sensor mobile part to the very end, in order to engage the
mobile part onto the fixed hooking system.
4. Carry out a movement towards the lower part, ensuring that the
movement is complete.
5. Only at this point, release the hooking lever, checking that the
sensor is correctly engaged before releasing the handgrip.
WARNING:
During the lever releasing operation, hold the sensor firmly, to prevent
the sensor from falling during the insertion phase due to possible errors.
NOTE:
All sensor types are equipped with a shock detection sensor; this sensor
is also visible from the outside to enable the operator to perform checks.
Possible shocks are displayed by a change in colour (from
transparent/white to red) of this sensor. The digital sensor can still
function correctly also when the colour changes, displaying a fall that
might also not have damaged the sensor.
NOTE:
The fallen sensor colour change interrupts the warranty on the sensor.


