RC-E User Manual
Management Client (RC-E Manager)
On-Net Surveillance Systems, Inc.
49
Owner authentication key:
See
Camera password.
Passwords
(for Dispatch Server)
:
Enter password. Must be identical to the one received from OnSSI.
Passwords
(for ST server)
:
Enter password. Must be identical to the one entered when the
Axis One-Click
Connection Component
was installed.
Register/Unregister at the Axis Dispatch Service:
Indicate whether you wish to register your Axis camera with
the Axis dispatch service. Can be done at time of setup or later.
Serial number:
Same as the MAC address. See
Camera password.
Use credentials:
If it was decided—during installation of the ST server—to use credentials, select the check box.
User name
(for Dispatch Server)
:
Enter user name. Must be identical to the one received from OnSSI.
User name
(for ST server)
:
Enter user name. Must be identical to the one entered when the
Axis One-Click
Connection Component
was installed.
Servers
Add Hardware (Cameras, etc.)
The
Add Hardware
wizard helps you detect IP hardware devices, such as cameras and video encoders, on your
network and add them to recording servers on your RC-E system.
To access
Add Hardware
, expand the
Servers
folder in the Management Client's Site Navigation pane (see "Panes
Overview" on page 36) and select the
Recording Server
node, then in the overview pane (see "Panes Overview" on
page 36) right-click the required recording server and select
Add Hardware...
The wizard offers you four ways of detecting and adding hardware devices:
Express (recommended)
,
Address range
scanning, Manual
and
Remote connect hardware
. With the
Express
option, RC-E automatically scans for available
hardware on the recording server's local network. With
Address range scanning, RC-E scans defined network IP
address ranges and detects hardware models. With Manual
, you manually specify the IP address and port for each
device. With
Remote connect hardware
, you can add hardware connected via a remotely connected server. All
options offer the possibility of automatically detecting the correct hardware drivers.
Tip:
If you are new to RC-E: use the
Express
hardware detection as it will guide you through each of the steps
involved in detecting and adding your IP devices.
It is strongly advised that you
only
add a physical hardware device to
one recording server
at the time.
Express
The
Express (recommended)
option automatically discovers hardware models on the recording server's local network.
1. Select
Express (recommended)
and click
Next
.
2. Specify user names and passwords if your hardware devices are not using the factory default user name and
password. You can add as many user names and passwords as required by clicking
Add
. Remember to
select the
Include
check box for each required device.
When ready, click
Next
.
3. Wait while the hardware is detected. A status indicator will show the detection process.
