RC-E User Manual
Installation and Removal
Recording servers (Custom)
The
Custom
option lets you select where to install the RC-E recording server components. A
Custom
installation is
recommended for advanced users.
1. Select required installation folder, then click
Next
.
2. When asked which type of server to install, click the
Standard recording server
[...] icon. This lets you install a
regular recording server.
3. Specify recording server setup parameters.
4. Click
Next
.
5. The wizard will ask you to select a user account under which the Recording Server service will run.
You must select between:
o
a predefined system account (see "Select a Predefined System Account" on page 19)
- or -
o
a particular user account (see "Select a Particular User Account" on page 20) (in which case the service
will use the specified user account to log in to the computer acting as recording server).
Tip
: If the computer acting as recording server is a member of a domain, select the predefined account
Local System or make sure you specify a user account which belongs to the domain in question.
If using network drives, you should always specify a particular user account (which has access to the
network drives in question), as the Recording Server service will not be able handle the network drives
otherwise.
6. Click
Next
.
7. In some cases it can be advantageous to install more than one instance of the recording server on the same
physical server (see "Multiple Recording Server Instances" on page 26). Specify the required number of
instances (default is 1), then click
Next
.
o
Only relevant if installing more than one instance of the recording server on the same physical server:
For each instance, specify the IP address to use for the instance in question.
IMPORTANT:
Note that the IP addresses you specify must be assigned to the physical server in
question. Furthermore, even though your organization will not use IPv6 addresses, make sure to assign
both IPv6 and IPv4 on the server as these are needed by the software.
Tip
: Provided enough IP addresses are assigned to the server, the fields will be pre-filled.
8. Click
Next
.
Select a Predefined System Account
1. Select
This predefined account
.
2. Select
Local System, Local Service
, or
Network Service
as applicable.
3. Click
OK.
On-Net Surveillance Systems, Inc.
19
