![background image](http://html1.mh-extra.com/html/omron/z500-series/z500-series_operation-manual_743394038.webp)
36
SE
CTION 2
2-3 Screen
Typ
es and
Disp
lay Meth
od
s
Z500
Operation Manual
SECTION 2
Basic Operations
2-3-4 Trend Monitor
Mostly used for setting and checking the Trigger function.
By using the Trend Monitor, the measurement results to be monitored can be checked in chronological
order for up to 30 seconds. Press the
TRIG
Key to switch from waveform display to waveform display
stop and vise versa. The trigger function enables waveform to be displayed at specified timing.
CHECK
Display range and display time can be changed. (Only the display range can be changed
for each output number.)
REFERENCE
Refer to page 118.
CHECK
Characteristic quantities (such as average value and peak value being held) at specified
timing can be output.
REFERENCE
Refer to page 84.
PASS
mm
+0005.18800
Zero's OFF
OUT 0
Thru
1div x: 1.000 [s]
y:+10.0000[mm]
9.96ms
S+ / :Display S+ENT:Adjust
Scn 0 Run
Screen Mode
Thru: The waveform obtained by the Sensor is displayed continuously.
Trig: A still image of the waveform based on the trigger settings is displayed.
Thin lines are used to represent the measurement start and measurement end timings.
Output number
The current output number is displayed.
Force-zero
Zero's OFF: Force-zero not executed
Zero's ON: Force-zero executed
Measurement period (Sampling time)
Trigger waveform
The trigger status is displayed.
Waveform display status
During waveform display, (green) is displayed.
While the waveform is stopped, (red) is displayed.
The units corresponding to 1 division (1 div) on the
waveform display are displayed. If the setting is
changed, the display also changes. Use these
values as reference when displaying the waveform.
1div x: 1.000
y:+10.000
1div
x
y
Conversion values
for X and Y axes
Measurement
value
Judgment result