99
Z500
Operation Manual
SECTI
ON 4
SECTION 4
Menus for Expert Menu
Contents of Display and Output
Note:
The numbers of the output terminals vary depending on the output numbers.
Profile
(Profile)
If there is a process line where the workpieces cannot be measured due to
different reflectance or other causes, the data of such line can be obtained by
interpolating the data acquired from the lines that allow measurement as
desired.
The asterisk (*) indicates the default setting.
Peak/bottom Measurement Width
(Peak/btm width)
The average over a specified region when measuring the peak or bottom is
output as the measurement value. The region can be specified in pixel units.
Setting a larger value will stabilize the measurement value.
The asterisk (*) indicates the default setting.
Display/Output
Hold
Clamp
Judgment results display
The previous
status is held.
ERROR is displayed.
Terminals Judgment output (See note.)
ERROR is output.
RS-232C
Measurement error is output.
Analog Output
4-20mA
22mA min.
±5V
+6V min.
Selection
Description
None
A measurement error signal is output for a portion interfering with the
measurement.
Intrpolate*
For a portion interfering the measurement, measured values obtained
before and after the error are interpolated and the result is output.
When selecting
None
:
When selecting
Intrpolate
:
Example:
An output profile of a portion interfering with the measurement.
A portion interfering
with measurement
A portion interfering
with measurement
A portion interfering
with measurement
Height
Position
Not interpolated
Interpolation by using
measurement data of
the neighboring areas
Selection
1pixel*, 5pixel, 9pixel, 13pixel, 17pixel,
21pixel, 25pixel, 29pixel,
Peak point
St
e
p
2
St
e
p
1
St
e
p
3
St
e
p
4
St
e
p
5
St
e
p
6
St
e
p
7