4-7
Section
Touch Switches
153
Touch Switch Attributes
The following attributes can be set for the Touch Switches.
•
Display frame
A display frame of the Touch Switch can be specified by the following two meth-
ods.
- Fixed-shape display frame
This is a frame displaying an area of display frame type that acts as Touch
Switch. There are four kinds of display frames as shown in the Table below:
“Standard”, “Solid 1”, “Solid 2”, “No Display Frame” (“Solid 2” is only available
with the NT620C).
When “No Display Frame” is selected, only the label is displayed (or nothing
if no label is specified) unless an ON (or flash) instruction is sent from the PC,
or the touch switch is pressed.
Display Frame Type
Switch OFF
Switch ON
Standard
Solid 1
Solid 2
No display frame
- Free-shape display frame
This is a display frame capable of freely setting the display position and
shape irrespective of Touch Switch area. A shape to be specified can be se-
lected out of “Square”, “Circle”, “Polygon”, and “Fan”.
For example, free-shape display frame can be used in the following manner.
When this position
is pressed
Touch Switch area
Display frame
Shown in reverse video
<Example of setting a display frame inside the Touch Switch area>
ÉÉÉ
ÉÉÉ
ÉÉÉ
When this position
is pressed
Touch Switch area
Display frame
Shown in reverse video
Summary of Contents for NT620C
