![background image](http://html1.mh-extra.com/html/omron/nt620c/nt620c_operation-manual_744559123.webp)
3-9
Section
System Maintenance
110
S
To change the existing setting, press the “Set” touch switch.
The “CALENDAR & CLOCK
SET” screen will be dis-
played (it will display the
time at the instant the “Set”
touch switch was pressed).
CALENDAR & CLOCK SET
Fri
0 5 – 1 9 – ’ 9 5
1 3
:
2 6
:
4 7
Push touch switch and set time,
after that push [Save Exit] please.
If you will cancel, push [Cancel] please.
Cancel
Save Exit
month
day
year
hour
min
sec
Each of the digits of the date, day, and time settings is a touch switch and the
value it displays can be changed incrementally (“0”
³
“1”
³
“2”
³
...) by pressing
the touch switch (note there is no carry over to the next higher digit if a full cycle is
completed).
Specify the date, day of the week, and time. Note that no strict input check is
performed: make sure that the settings are correct.
S
On completing setting, press the “Save Exit” touch switch. The calendar and
time specifications will be set and the CALENDAR & CLOCK CHECK screen
will be redisplayed.
S
To cancel the settings, press the “Cancel” touch switch. This will redisplay the
CALENDAR & CLOCK CHECK screen without setting the specified date and
time.
S
Calendar and clock setting can also be executed by operation from the Tool
Settings screen of the support tool, or by using numeral memory table opera-
tions. For details on the setting procedure when using the support tool, refer to
the NT-series Support Tool Operation Manual (V028-E1-
j
), and for details on
the setting procedure using numeral memory tables, refer to 5-6 “Clock Func-
tion” (page 229).
Checking the backlight (NT620C)
Check the NT620C backlight by following the menu operation from the System
Menu described below. Note that the NT620S, which has an EL display, has no
backlight check function.
Select “Maintenance Mode”.
Select “I/O Check”.
Select “Backlight”.
S
If the backlight is functioning normally, it flashes on and off.
S
On completion of the check, press the “Quit” touch switch. The display returns
to the “I/O CHECK MENU”.
Summary of Contents for NT620C
