Omron NT620C, Operation Manual

Page: 172 / 337

4-8 Section Numeral Setting
160
Therefore, the thumb wheel type can perform an entry of numeral value only by
creating the numeral setting input column in a screen.
Each time the “–” key is touched,
a numeral value decreases by
“1”.
PC
1234
Writing
Numeral Memory Table
Notifying
NT620S/620C
Each time the “+” or “–” key is touched, an in-
put value is written into the numeral memory
table and simultaneously notified to the PC.
Each time the “+” key is touched,
a numeral value increases by “1”.
1 3
+ + +
2 4
+
– – – –
4-8-3 Ten-Key Creation
In order to use the ten-key type numeral setting, it is necessary to create not only
the numeral setting input column in a screen but also a ten-key for performing an
input operation.
Screen Attribute Setting
A ten-key type can be selected by setting a screen attribute.
The “Numeral Setting” of the screen attribute is specified to “System” or “User”.
•
Screen when “System” is specified
When a numeral setting input field is created, numeric keys are automatically
displayed.
Ten-key display position and arrangement are fixed. In this screen, only the
type of ten-key (system key) in the following page can be used.
1 2 3 4 5 6 7 8 9 0 . +/–
CLR
Tank A Tank B
Tank D
Tank F
Tank C
Tank E
0000 0000
0000
0000
0000
0000
•
Screen when “User” is specified
Display position and arrangement of the ten-key can be set freely by assigning
to the touch switch (Refer to page 162).
Tank A Tank B
Tank D
Tank F
Tank C
Tank E
CLR SET
5000 3000
2662 1204
0800 0990
When the “numeral setting Keypad” attribute is “user”, the numeric keys are
created by using the control keys of the touch switch “input key” function. It is
also possible to use the character keys of the “input key” function to create nu-
meric keys with one-byte characters 0 to 9 and A to F.