Omron CX-Programmer 9, Operation Manual

Page: 272 / 542

PART 2: CX-Server PLC Tools
CHAPTER 3 – IO Table Component OMRON
CX-Server PLC Tools_Page 22
Displaying an I/O Table
Displaying the CS/CJ/CP I/O Table Window
The CS/CJ/CP I/O Table Window is displayed when the PLC is a CS/CJ/CP-series PLC.
Rack’s starting CIO address
Slot number
Unit’s starting CIO address
Unit model
(See note.) Unit name
Number of Unit
resources occupied
by Special I/O Unit
Special I/O Unit’s
unit number
Number of output words
and number of input
words
Note: The Unit model will be blank if there is no CPS file.
The Unit model will also be blank when data for C200H Special I/O
Units has been uploaded from the PLC (Transfer from PLC).
Note:
In the CS/CJ I/O Table Window, the current consumption and width for each PLC
Rack can be displayed as shown below by selecting
Options - Consumption and
Width .
When Units which do not have CPS are registered in the I/O tables, the current
consumption and width cannot be calculated correctly. In this case, estimated values
marked with "*" are displayed for the current consumption and width as shown below.
Specifically, when a previous model of a Unit (such as C200H I/O Units) is used,
estimated values may be displayed.
In this case, check the current consumption and width in the Operation Manual of the
Unit.
Online, the current status of the DIP switches on the target PLC (CPU Unit) can be
checked by selecting
Options - DipSwitch Information.