Omron CX-Programmer 9, Operation Manual

Page: 122 / 542

PART 1: CX-Programmer
CHAPTER 3 – Project Reference OMRON
CX-Programmer _Page 42
Use the following procedures to insert, rename, move or delete a section in a program.
1, 2, 3… 1. Inserting a new program section
(a) Select the program name in the Project tree.
(b) Click the Insert pushbutton in the toolbar or from the Insert menu select Section .
The new section will be added to the bottom of the section list before the ‘END’
section.
Note that if previous sections have been renamed the new section will be named
Section1 , if not, it will be given the next section number.
2. Renaming a program section
(a) Select the section to be renamed and click the right mouse button. From the context
menu select Properties.
(b) In the Properties dialog enter the new name for the section and then close the
dialog. The new section name will be displayed in the section list.
3. Moving a program section
(a) Select the program section to be moved, and from the Edit menu select Cut . Move
to the location of the program (the program item on the project workspace) for the
section to be placed, and select
Paste from the Edit menu. Then using the mouse
drag and drop the section in the appropriate position in the section list.
(b) Instead of using the Edit commands, it is possible to drag and drop the section. Drag
the section to the program item where it is required.
Note that when the section is dropped, it will reposition its self immediately below the
cursor. To drag a section to the top of the list, it must be dropped on the program item
itself.
A section may be moved to another program, or just within the same program, in which
case it changes the execution sequence of the sections.
(b) When using the keyboard the 'Move Up' or 'Move Down' commands from the
context menu of a section in the project workspace are used. Each command will
move the selected section up or down one position at a time.
4. Copying a program section
(a) Select the section to be copied, and from the Edit menu select Copy . Move to the
location of the program (the program item on the project workspace) for the copy to
be placed, and select
Paste from the edit menu.