O
PERATION
:
C
ONFIGURATION
M
ODE
part
3
53
Output 2
cont.
Display
Action
Response
ACTION TYPE SUBMENU:
Press ENTER
6) Display flashes
"
drCt
"
or
"
rUrs
"
.
Press MAX
7) Scroll through the available selections:
Direct
or
Reverse
.
Press ENTER
8) Display flashes
"
strd
"
message and advances to
"
Auto PID
"
submenu.
If
"
ON/OFF
"
was selected in the Control Type, the display skips to the
"
Deadband
"
submenu.
The error that results from the measurement of the process variable may be positive or negative since it may be greater or
smaller than the set point. If a positive error should cause the controller output to increase (i.e. cooling), it would be called
Direct Acting
. If a negative error should cause the output to increase (i.e. heating), it would be called
Reverse Acting
.
ACTN
DRCT
ACTN
TYPE
Note
☞
Summary of Contents for MICROMEGA CN77000 series
