Oce ColorWave 650, User Manual

Page: 311 / 336

Calibration error codes
Introduction
Before or during the calibration, it is possible that the calibration failed. If this is the case,
you will be informed immediately through an error code on the printer operator panel.
Caution:
Error codes are only displayed at the printer operator panel. If an error code is displayed
that is not related to the calibration process, the user must follow the instructions on the
printer operator panel to solve the problem.
Note:
For feedback about errors related to the processing of print jobs open the event list in
the 'Jobs' tab.
Overview calibration error codes
#
Remarks Action Error-code
Roll not loaded Calibration not accepted: 22917
Roll too small Calibration not accepted: 22918
Media type not suitable for instal-
lation calibrations Calibration not accepted: 22919
Media type not suitable for Y-
alignment Calibration not accepted: 22920
Media type not suitable for pa-
per step calibration Calibration not accepted: 22921
External output not available for
delivery Calibration not accepted: 22922
Printer engine status is not
standby or the folder (if config-
ured) is offline or turned off Calibration not accepted: 22923
Out of toner during calibrations Calibration failed: 22924
Out of media during calibrations Calibration failed: 22925
Chapter 8 - Print quality and Print productivity 311
Calibration error codes