Oce Arizona 365 GT, User Manual

Page: 66 / 234

How to Power ON and Off
Introduction
It is critical for the printer to remain powered ON at all times. Power is required in periods of
inactivity so the printer can perform automatic functions to maintain its operating state. If these
functions do not take place, damage to critical components can occur. However, it may be
necessary on occasion to cycle power on the printer or to recover from a power outage.
How to Power ON
Procedure
1.
Ensure that the AC power plug is properly seated.
2.
Turn the AC power switch to the On position.
[35] AC Power Switch
3. Turn on the power of the Control Station LCD monitor, if necessary.
NOTE
During the boot-up procedure, the printer software is automatically started. The
software displays a splash screen.
The splash screen will show initialization messages and then the Print Job Control
module screen appears. The initialization is complete when the top left panel of the
display shows "Ready". Your printer is now ready for use.
How to Power Off
IMPORTANT
After powering the printer On, leave it running continuously, even when at idle. Failure to leave
the printer powered on may result in ink draining out of the ink reservoirs. It may also result in
damage to the printheads. Leave the printer powered On at all times, unless service to electrical
components is required.
NOTE
The printer is designed to be left powered ON at all times as only minimal power is consumed
when the printer is idle.
How to Power ON and Off
66 Chapter 5 - How to Operate Your Océ Arizona Printer