Oce Arizona 365 GT, User Manual

Page: 65 / 234

How to Manage Printer Operations
Daily Start-up and Shut-down - Start-up Procedure
Introduction
Keep your printer clean and perform all recommended scheduled maintenance to ensure that the
printer is ready to produce optimal quality images.
When to do
The start-up procedure must be performed every morning or after a period of time when the
printer has not been used. The shut-down procedure indicated here is for the end of a regular
workday. If the printer is shut down for longer periods of time than a few days, then there are
more considerations, as documented in the previous section on How to Switch the Printer Off
(see the note on Extended Power Off).
Before you begin
Review the sections on hardware and software interface if you are not familiar with the
Command Toolbar and other components mentioned in this section.
Start-up Procedure
NOTE
Make sure the ink is up to temperature before you perform Printhead Maintenance.
1. Turn on the Ink Heater (click on the Ink Temperature Control icon located on the Command
Toolbar of the Job Control screen).
2. Clean the carriage underside.
3. Perform Printhead Maintenance after the ink temperature has reached at least 40° Centigrade.
Shut-down Procedure
1. Turn off the UV lamps (click on the lamp icon located on the Command Toolbar of the Job
Control screen).
2. Turn off the table vacuum.
3. If it is the end of the work week, swab the printheads.
4. Turn off the ink heater (click on the Ink Temperature Control icon located on the Command
Toolbar of the Job Control screen).
5. Do not power off the printer (unless the printer will not used for more than 14 days - in that
case call your service representative).
How to Manage Printer Operations
Chapter 5 - How to Operate Your Océ Arizona Printer 65