Nord Drivesystems SK 180E Series, User Manual

Page: 133 / 212

5 Parameter
BU 0180 en-4118 133
P483
[-01]
...
[-10]
Hyst. BusIO Out Bits
(Hysteresis of Bus I/O Out Bits
)
S
1 … 100 %
{ all 10 } Difference between switch-on and switch-off point to prevent oscillation of the output signal.
[-01] = Bus / AS-i Dig Out1
(Bus IO Out Bit 0 + AS-i 1)
[-02] = Bus / AS-i Dig Out2
(Bus IO Out Bit 1 + AS-i 2)
[-03] = Bus / AS-i Dig Out3
(Bus IO Out Bit 2 + AS-i 3)
[-04] = Bus / AS-i Dig Out4
(Bus IO Out Bit 3 + AS-i 4)
[-05] = Bus / IOE Dig Out1
(Bus IO Out Bit 4 + DO 1 of the
first
SK xU4
-
IOE (DigOut 02))
[-06] = Bus / IOE Dig Out2
(Bus IO Out Bit 5 + DO 2 of the
first
SK xU4
-
IOE (DigOut 03))
[-07] = Bus / 2nd IOE Dig Out1
(Flag1 + DO 1 of the
second
SK xU4
-
IOE (DigOut 04))
[-08] = Bus / 2nd IOE Dig Out2
(Flag2 + DO 2 of the
second
SK xU4
-
IOE (DigOut 05))
[-09] = Bit 10 BUS status word
[-10] = Bit 13 BUS status word
NOTE: Details for the use of the relevant bus systems can be found in the applicable supplementary bus
manual.
5.2.6 Additional parameters
Parameter
{factory setting}
Setting value / Description / Note Supervisor Parameter set
P501
[-01]
...
[-20]
Inverter name
(Inverter name)
A…Z
(char)
{ 0 }
Free input of a designation (name) for the device (max. 20 characters). With this, the frequency
inverter can be uniquely identified for setting with NORD CON software or within a network.
P502
[-01]
...
[-03]
Value master function
(Master function value)
S P
0 ... 57
{ all 0 }
Selection of master values of a Master for output to a bus system (see P503). These master
values are assigned at the slave via (P546):
[-01] = Master value 1 [-02] = Master value 2 [-03] = Master value 3
Selection of possible setting values for master values:
00 = Off
01 = Actual frequency
02 = Actual speed
03 = Current
04 = Torque current
05 = Digital IO status
06 = reserved
07 = reserved
08 = Setpoint frequency
09 = Error number
10 = reserved
11 = reserved
12 = BusIO Out Bits0-7
13 = reserved
14 = reserved
15 = reserved
16 = reserved
17 = Value analogue input 1
18 = Value analogue input 2
19 = Setpoint frequency Master
value
20 =
Setpoint frequency after
master value ramp
21 = Actual frequency without
master value slip
22 = Speed encoder
23 = Actual frequency with slip
24 = Master value, actual
frequency with slip
53 = Actual value 1 PLC
54 = Actual value 2 PLC
55 = Actual value 3 PLC
NOTE: For details regarding the processing of setpoints and actual values, pleas refer to

Section 8.9 "Standardisation of setpoint / target values".