Nord Drivesystems SK 180E Series, User Manual

Page: 74 / 212

NORDAC BASE (SK 180E / SK 190E) – Users Manual for Frequency Inverters
74 BU 0180 en-4118
"Ø" =
Parameter has no significance "-" = Leave the parameter in the factory setting
"√" = Setting of the parameter is relevant "!" = Setting of the parameter is important
Group Parameter Operating mode
VFC open-loop CFC open-loop
ASMs PMSMs ASMs PMSMs
M
ot
or
d
at
a
P201 … P209 √ √ √ √
P208 ! ! ! !
P210 √ 1) √ √ √
P211, P212 - 2) - - -
P215, P216 - 1) - - -
P217 √ √ √ √
P220 √ √ √ √
P240 - √ - √
P241 - √ - √
P243 - √ - √
P244 - √ - √
P246 - √ - √
P245, 247 - √ Ø Ø
C
on
tr
ol
le
r d
at
a
P300 √ √ √ √
P301 Ø Ø Ø Ø
P310 … P320 Ø Ø √ √
P312, P313, P315, P316 Ø Ø - √
P330 … P333 - √ - √
P334 Ø Ø Ø Ø
1) = For V/f characteristic curve: precise matching of the parameter is important.
2) = For V/f characteristic curves: typical setting "0"
4.2.3 Motor control commissioning steps
The main commissioning steps are mentioned below in their ideal order. Correct assignment of the
inverter / motor and the mains voltage is assumed. Detailed information, especially for optimisation of
the current, speed and position control of asynchronous motors is described in the guide "Control
optimisation" (AG 0100). Please contact our Technical Support.
1. Make
the motor connection as usual (note ∆ / Y!)
2. Connect the mains supply.
3. Carry out the factory setting (P523)
4. Select the basic motor from the motor list (P200) (ASM types are at the beginning of the list, PMSM
types are at the end, designated by their type (e.g. …80T… ))
5. Check the motor data (P201 … P209) and compare with the type plate / motor data sheet
6. Measure the stator resistance (P220)

P208, P241[-01] are measured, P241[-02] is calculated.
(Note: is an SPMSM is used, P241[-02] must be overwritten with the value from P241[-01])
7. with PMSM only:
a. EMF voltage (P240)

motor type plate / motor data sheet
b. Determine / set reluctance angle (P243) (not required with NORD motors)
c. Peak current (P244)

motor data sheet
d. Only for PMSMs in VFC mode:
determine (P245), (P247)
e. Determine (P246)