The parameters described below are presented as they appear in the Control area (Ar-
range view). The same parameters are available in the Plug-in panel within the Plug-in
for more information on this.
Element
Description
MAIN Section
Engine
Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to
.
Tune
Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 36.00 to
60.00. The default value is 48.00. For more details see
Pitch Range, Tuning, and MIDI Notes
Decay
Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Snap
Emulates the air movement caused by the beater before the drum is
hit. Therefore, it produces a snap in the waveform the length of
which can be controlled through this parameter. Available values
range from 0.0 to 100.0 % (default: 50.0 %).
Impact
Adjusts how hard the drum is hit, measured as a percentage.
Available values range from 0.0 % (softest) to 100.0 % (hardest).
The default value is 75.0 %.
PUNCH Section
Mode
Selects from two different punch modes:
A
(default) and
B
.
Decay
Adjusts the duration of the punch, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Amount
Adjusts the amount of punch, measured as a percentage. Available
values range from 0.0 to 100.0 % (default).
Advanced Page
For this engine the
Advanced
page does not contain any parameters.
Using the Drumsynths
The Kicks
MASCHINE 2 - Manual - 392
