Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 418 / 501

How to change a tyre
For emergencies 8-11
8
3. Using the jack handle, turn the release
valve (D) clockwise until it stops.
4. Insert the jack handle in the bracket of the
jack and hook the notch (E) on the jack
handle end to the claw (F) of the bracket.
5. Move the jack handle up and down to
raise the ram until just before the jack
contacts the jacking point of the vehicle.
Ensure that the jack will properly contact
the vehicle jacking point.
Move the jack handle up and down to
raise the vehicle.
A- Front jacking point
B- Rear jacking point
WARNING
 Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
 Do not use the jack on a tilted or soft sur-
face. Otherwise, the jack might slip and
cause personal injury. Always use the jack
on a flat, hard surface. Before setting the
jack, make sure there are no sand or peb-
bles under the jack base.
NOTE
 When jacking up the rear of the vehicle, turn
the tip of the jack so that the grooved portion
(C) properly meets the designated point.
WARNING
BK0240501EN.book 11 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分