Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 158 / 501

Headlamp levelling
Instruments and controls 5-61
5
4. The headlamps will come on in the low
beam setting for approximately 30 sec-
onds. After the headlamps go off, the
headlamps can be turned on again in the
low beam setting for approximately
30 seconds by pulling the turn-signal
lever towards you within 60 seconds of
turning the ignition switch to the “OFF”
position or putting the operation mode in
OFF.
To turn on the headlamps again after
60 seconds of turning the ignition switch
to the “LOCK” position or putting the
operation mode in OFF, repeat the process
from step 1.
E00517400031
E00517501912
The angle of the headlamp beam varies
depending upon the load carried by the vehi-
cle.
The headlamp levelling switch can be used to
adjust the headlamp illumination distance
(when the lower beam is illuminated) so that
the headlamps’ glare does not distract other
drivers.
Set the switch according to the following
table.
5 - person seat
 : 1 person
:Full luggage loading
NOTE

While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn-signal lever towards you.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The time that the headlamps remain on can
be changed.
• The coming home light function can be
deactivated.
For further information, please contact your
authorised MITSUBISHI MOTORS dealer.
Headlamp levelling
Headlamp levelling switch
(except for vehicle with LED
headlamps)
*
CAUTION
 Always perform adjustments before driving.
Do not attempt to adjust while driving, as it
could cause an accident.
Vehicle condition Switch position
“0”
“0”
“1”
“3”
“4”
Switch position 0-
BK0240501EN.book 61 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分