Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 220 / 501

Super select 4WD II*
Starting and driving 6-53
6
E00651000025
Vehicles equipped with the mono-color liquid
crystal display, refer to “2WD/4WD opera-
tion indicator lamp and low-range indicator
lamp” on page 6-54. Vehicles equipped with the color liquid crys-
tal display, refer to “Drive mode indicator
display and 2WD/4WD operation indicator
4HLc 4LLc Stop the vehicle, depress the clutch pedal to the floor and
operate the drive mode-selector.
Keep depressing the clutch pedal while the 2WD/4WD
operation indicator lamp/display continues to blink.
Stop the vehicle, shift the selector lever to the “N” (NEU-
TRAL) position, depress and hold the brake pedal, and
operate the drive mode-selector.
If operation is made with the selector lever placed in any
other position than “N” (NEUTRAL) position or release
the brake pedal, a gear noise may be generated, with a
possible failure to shift into a proper gear.
4LLc 4HLc
NOTE
 Setting of the drive mode-selector between “2H”, “4H” and “4HLc” should only be done at speeds below
62 mph
.
 During driving, never attempt to shift from “4HLc” to “4LLc”.
 When shifting between “2H”, “4H” and “4HLc” in cold weather while the vehicle is in motion, the transfer gear may make some noise. In cold weather,
try
to shift the gear while the vehicle is stopped.

When shifting between “4LLc” and “4HLc”, the transfer gear may make some noise.
 When the drive mode-selector is set between “2H”, “4H” and “4HLc” while the vehicle is stopped, the 2WD/4WD operation indicator lamp/display
blinks
while the selection is in process. Drive slowly and normally after confirming that the display is illuminated. (Refer to “Drive mode-selector
position, drive mode indicator display, 2WD/4WD operation indicator lamp/display and low-range indicator lamp” on page 6-50.)

When the drive mode-selector is set between “2H”, “4H” and “4HLc” while the cruise control or the Adaptive Cruise Control System (ACC) is
activated,
the transfer gear may make some noise.
 When the drive mode-selector is set between“4HLc”
↔
“4LLc” in cold weather, its selection may not complete. Return the drive mode-selector to its pre-
vious position. After the engine is warmed up, make the range selection again.
CAUTION
 Do not operate the drive mode-selector while the rear wheels of the vehicle are slipping on snow or ice.
To shift from To
Procedure
Vehicles with M/T Vehicles with A/T
Indicator lamp/display
BK0240501EN.book 53 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分