Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 280 / 501

Ultrasonic misacceleration Mitigation System (UMS)*
Starting and driving 6-113
6
E00643800040
The Ultrasonic misacceleration Mitigation
System is automatically turned ON by setting
the operation mode to ON. In addition, the
Ultrasonic misacceleration Mitigation System
ON/OFF is switched in conjunction with the
ON/OFF state of the FCM.
Refer to “Forward Collision Mitigation Sys-
tem (FCM) and Ultrasonic misacceleration
Mitigation System (UMS) ON/OFF switch”
on page 6-107.
E00643900054
E00647600059
Example: When the front and/or rear sensors
are temporarily not available
When the warning display appears, the sen-
sors are temporarily not available for some
reason such as the environmental condition or
increase of the sensor temperature. When the
warning display does not disappear after
waiting for a while, contact an authorised
MITSUBISHI MOTORS dealer.
CAUTION
 The Ultrasonic misacceleration Mitigation
System may not operate because the sensor
cannot detect the vehicle or obstacle as fol-
lows.
• Vehicle towing a trailer etc.
• A freight trailer that is not carrying a con-
tainer.
• Vehicle that has a protruding load from the
carrier.
• Obstacles that have low positions.
• Vehicle that is extremely stained.
• Vehicle or obstacle that is covered with
snow.
• A large mesh screen fence.
• The vehicle is the specific shape such as the
carrier car.
• Obstacles that have irregular surface.
• Obstacles that have the shape of the pole
such as the road marker or the streetlight.
• Obstacles that exists in the high position
from the ground.
• Obstacles that are soft and absorb ultra-
sonic easily, such as spongy material or
snow.
• Obstacles that are shaped with a sharp
angle.
• A wall surface is not flat
NOTE
 If the bumper has been exposed to an impact,
the sensors may fail and prevent the system
from functioning properly. Have the vehicle
inspected at an authorised MITSUBISHI
MOTORS dealer.
 The sensors do not detect objects located in
the area directly below or near the bumper. If
the height of an object is lower than the
mounted position of the sensors, the sensors
may not continue detecting it even if they
detected it initially.
To turn on/off the Ultrasonic
misacceleration Mitigation Sys-
tem
CAUTION
Warning display
When the sensor is temporarily
not available
BK0240501EN.book 113 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分